Turn off printer and allow to cool for at least 20 minutes before proceeding.
From the back of the printer press the 2 tab towards the centre to open the door.
Located on the left side, pinch the plastic support strap. Squeeze the tab while pulling up to remove the strap, try wiggling and tugging to get the it out.
Gently remove the door, remember how it comes out for re-install.
Remove the two screws (circled on picture below). Place a a small flat blade screwdriver at the red rectangle (below) to slightly lift the fuser. This will lift the fuser from its seated position. Holding the 2 green handles gentle pull the fuser out.
That’s it, installation is reverse.
